Cylinder Piaggio/Vespa 4-stroke 80cc 49mm 3117771 Malossi

Want to step up the Piaggio/Vespa scooter? This Malossi 80cc cylinder is suitable for all Piaggio/Vespa 50cc 4-stroke engines.

Properties: Malossi 80cc Piaggio 4-stroke cylinder

• Size: 49 mm
• 80 cc cylinder capacity
• Material: aluminum
• Air-cooled (A.c)
• Piston pin 13 mm
• Piston and gaskets included

NOTE: for the iget motors, only to be used in combination with Malossi injectronic control unit (ecu) 5518409!

Malossi

With Malossi, you are assured of high quality and performance. Malossi mainly makes motor scooter parts for circuit use. Malossi also has homologated parts (approved for public roads)

Are you unsure whether this cylinder fits your scooter? Watch “beware” below

When does a cylinder need to be replaced?

A Malossi cylinder, for example, is an essential part of your Piaggio 4-stroke scooter. A cylinder needs to be replaced if there is a scratch or bumper in the wall, so the Piaggio 4-stroke cylinder loses compression. Compression is the compression of the fuel/air mixture in the cylinder. With little or no compression, the engine of your Piaggio 4-stroke scooter will no longer start or drive poorly. A scratch or bumper is a noticeable unevenness in the cylinder wall. As a result, if only the piston is replaced, this new piston can also be damaged immediately on your Piaggio 4-stroke scooter! If a Piaggio 4-stroke scooter is poorly adjusted or has too little oil, the wear and tear on your Malossi 80 cc cylinder is a lot greater.

Suitable for all Piaggio/Vespa 50cc 4-stroke engines

Attention! The set includes two cylinder foot gaskets with different thicknesses:
- 0.40 mm: suitable for use with the 4-stroke 2- or 4-valve engine
- 0.80 mm: suitable for use with the 4-stroke 3-valve engine